Removing And Replacing The Display Unit - Navman TRACKFISH 6500 Installation And Operation Manual

Changing the plug-in card
Warning: Handle plug-in cards carefully. Keep them in their protective cases when not plugged
into the TRACKFISH.
Warning: Keep the holder in place in the TRACKFISH at all times to prevent moisture from
entering the card compartment.
1
Turn the TRACKFISH off (see section 2-2).
Pull the card holder out of the TRACKFISH and
pull any card out of holder.
Put the card in its case.

1-4 Removing and replacing the display unit

If the display unit is bracket mounted then
the display unit can easily be removed and
replaced for security or protection.
Removing the display unit:
1 Turn the display unit off (see section 2-2)
and put the dust cover on.
2 Loosen the knob on the mounting bracket
and lift the unit off the bracket.
3 Unplug the connectors from the
display unit; turning each locking collar
anticlockwise until you can pull the
plug out.
4 Push the attached dust covers over the
exposed ends of the connectors.
5 Store the display unit in a dry clean place,
such as the optional Navman carry bag.
Replacing the display unit
1 Remove the dust covers from the
connectors. Plug the connectors into the
back of the display unit:
Match the connector's colour to the
socket colour.
TRACKFISH 6500 Installation and Operation Manual
2
Gold contacts under here
3
Card
Holder
Push new card into holder. Ensure the gold
contacts are on the outer edge and underneath
(see above).
Keep the card's case.
Push card holder fully into TRACKFISH
Insert each connector and turn the
locking collar clockwise until it is finger
tight.
Nothing will be damaged if a cable is
plugged into the wrong socket by mistake.
2 Hold the display unit in place on the
mounting bracket. Adjust the tilt of the
display for best viewing, then hand tighten
the knob on the mounting bracket. Remove
the dust cover.
Knob
NAVMAN
4
Mounting
bracket
9