When Pictbridge Printing Does Not Work - Ricoh SP C242DN Software Manual

4. Direct Printing from a Digital Camera (PictBridge)

When PictBridge Printing Does Not Work

This section explains likely causes and possible solutions for problems that can occur at PictBridge
printing.
Problem
PictBridge is not available.
4
When two or more digital
cameras are connected, the
second and subsequent
cameras are not recognized.
Printing is disabled.
Printing is disabled.
44
Cause
There is a problem with the USB
connection or the PictBridge
settings.
You have connected multiple
digital cameras.
The specified number exceeds
the maximum number that can
be printed at a time.
There is no paper of the
specified size remaining.
Solution
Use the following procedure to
check the connection and
settings:
1. Disconnect and then
reconnect the USB cable.
2. Check the PictBridge
settings are enabled.
3. Disconnect the USB cable,
and then turn off the
printer.
Turn the printer back on.
When the printer has fully
booted up, reconnect the
USB cable.
Connect one digital camera
only.
Do not connect multiple
cameras.
The maximum specifiable print
quantity at a time is 999.
Respecify the quantity to 999 or
less, and then retry printing.
There is no paper of the
specified size remaining.
If you have to use paper that is
not of the specified size,
continue printing using
mismatched paper. To cancel
printing, perform Job Cancel.
For details, see p.19 "If a Paper
Mismatch Occurs".