When Pictbridge Printing Does Not Work - Ricoh AficioSP C410DN Software Manual

Direct Printing from a Digital Camera (PictBridge)

When PictBridge Printing Does Not Work

This section explains likely causes and possible solutions for problems that can
occur when PictBridge printing.
Problem
PictBridge is not available.
4
When two or more digital
cameras are connected, the
second and subsequent cam-
eras are not recognized.
Printing is disabled.
Printing is disabled.
Printing is disabled.
128
Cause
There is a problem with the
USB connection or the Pict-
Bridge settings.
You have connected multiple
digital cameras.
The number of originals ex-
ceeds the maximum number
of pages that can be printed at
a time.
There is no paper of the speci-
fied size remaining.
The paper size setting for this
tray cannot be printed on the
printer.
Solution
Use the following procedure
to check the connection and
settings:
A
Disconnect and then re-
connect the USB cable.
B
Check the PictBridge set-
tings are enabled.
C
Disconnect the USB cable,
and then turn off the print-
er. Turn the printer back
on. When the printer has
fully booted up, reconnect
the USB cable.
Connect one digital camera
only.
Do not connect multiple cam-
eras.
The maximum specifiable
print quantity at a time is 999.
Respecify the quantity to 999
or less, and then retry print-
ing.
There is no paper of the speci-
fied size remaining.
If you have to use paper that is
not of the specified size, per-
form Form Feed. To cancel
printing, perform Job Cancel.
Select the paper size setting
that can be printed on the
printer.