Table of Contents
Advertisement
Y/KSCF/C/HC18G HIGH EFFICIENCY COOL ZONE SERIES GAS FRYERS
7.3 Filtration System Troubleshooting
Pump won't
start.
Pump stops
during filtering
process. Motor
is hot.
Pump stops
and motor is
cool.
Pump starts
and abruptly
stops.
Pumping is
erratic.
Oil not being
returned to
frypot.
After filtering,
fryer does not
operate
properly.
CHAPTER 7: TROUBLESHOOTING
•
Return valve not fully opened.
•
Tripped circuit breaker.
•
Incorrect or no line voltage.
•
Failed or misadjusted return microswitch.
•
Allow motor to cool for at least 45 minutes and then
press thermal overload switch on motor.
•
Move filter handle to OFF. Allow oil to cool then
empty pan. Verify filter paper and screen are clean
and properly installed. Refill pan and restart
process.
•
Reset thermal overload.
•
Verify wiring harness is properly connected; a
damaged harness should be replaced by a FASC.
•
Pump is blocked. Call FASC for service.
•
Filter pan suction tube is blocked. Use a thin,
flexible wire to unclog.
•
Motor or 24 VAC transformer failed; call for service.
•
Verify O-rings on pan outlet are present and in good
condition.
•
Verify paper and screen have been properly
installed.
•
Solidified oil or sediment is likely clogging the return
line. Clear line.
•
Verify drain valve is fully closed.
7-7
Advertisement
Table of Contents
