Table of Contents
Advertisement
The Operator Panel
1
Turn on the printer.
Ensure that Ready message appears on the LCD panel.
2
On the operator panel, press the
3
Select Admin Menu, and then press the
4
Select Network Setup, and then press the
5
Select TCP/IP, and then press the
6
Select IPv4, and then press the
7
Select Get IP Address, and then press the
8
Ensure that Panel is selected, and then press the
9
Ensure that Get IP Address is selected.
10
Select IP Address, and then press the
The cursor is located at the first digit of the IP address.
11
Enter the value of the IP address using the
12
Press the
button.
The next digit is selected.
13
Repeat steps
11
14
Press the
(Back) button, and then ensure that IP Address is selected.
15
Select Network Mask, and then press the
The cursor is located at the first digit of the network mask.
16
Enter the value of the network mask using the
17
Press the
button.
The next digit is selected.
18
Repeat steps
16
19
Press the
(Back) button, and then ensure that Network Mask is selected.
20
Select Gateway Address, and then press the
The cursor is located at the first digit of the gateway address.
21
Enter the value of the gateway address using the
22
Press the
button.
The next digit is selected.
23
Repeat steps
21
(Menu) button.
button.
to
12
to enter all of the digits in the IP address, and then press the
to
17
to set network mask, and then press the
to
22
to set gateway address, and then press the
button.
button.
button.
button.
(Back) button.
button.
or
button.
button.
or
button.
button.
or
button.
button.
button.
button.
Network Basics
60
Advertisement
Table of Contents
