Fuji Xerox DocuPrint CP205 User Manual page 170

WPS
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
• Init Wireless (DocuPrint CP205 w Only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all
wireless network settings are reset to their factory default values.
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
• TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
IP Mode
IPv4
• Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
LPR
169 Using the Operator Panel Menus
Push Btn. Ctrl Configures the wireless setting with the security method of WPS-
PBC.
PIN Code Start Config.
Print PIN Code Prints the PIN code. Confirm it when you enter the
Dual Stack*
IPv4 Mode
IPv6 Mode
Get IP DHCP/AutoIP*
Address
BOOTP
RARP
DHCP
Panel
IP Address
Network Mask
Gateway Address
Disable
Enable*
Configures the wireless setting using the PIN code
assigned automatically by the printer.
PIN code to your computer.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator
panel.
Manually sets the IP address allocated to the
printer.
Manually sets the subnet mask.
Manually sets the gateway address.
Disables the Line Printer Daemon (LPR) port.
Enables the LPR port.