Configuring LACP
Use the following procedure to configure LACP for port EXT1 and port EXT2 to participate in
link aggregation.
1.
Set the LACP mode on port EXT1.
2.
Define the admin key on port EXT1. Only ports with the same admin key can form a
LACP trunk group.
3.
Set the LACP mode on port EXT2.
4.
Define the admin key on port EXT2.
5.
Apply and verify the configuration.
6.
Save your new configuration changes.
42C4911, January 2007
>> # /cfg/l2/lacp/port EXT1
>> LACP port EXT1# mode active
>> LACP port EXT1# adminkey 100
Current LACP port adminkey:
New pending LACP port adminkey: 100
>> # /cfg/l2/lacp/port EXT2
>> LACP port EXT2# mode active
>> LACP port EXT2# adminkey 100
Current LACP port adminkey:
New pending LACP port adminkey: 100
>> LACP port EXT2# apply
>> LACP port EXT2# cur
>> LACP port EXT2# save
Alteon OS Application Guide
(Select port EXT1)
(Set port EXT1 to LACP active mode)
(Set port EXT1 adminkey to 100)
17
(Select port EXT2)
(Set port EXT2 to LACP active mode)
(Set port EXT2 adminkey to 100)
18
(Make your changes active)
(View current trunking configuration)
(Save for restore after reboot)
Chapter 4: Ports and Trunking
103