Rstp Configuration Example - Nortel Alteon OS 42C4911 Application Manual

Alteon OS Application Guide

RSTP Configuration Example

This section provides steps to configure Rapid Spanning Tree on the GbE Switch Module,
using the Command-Line Interface (CLI).
Configure Rapid Spanning Tree
1. Configure port and VLAN membership on the switch.
2. Disable and clear STP groups 2 through 126.
>> /cfg/l2/stg 2
>> Spanning Tree Group 2# clear
>> Spanning Tree Group 2# off
3. Set the Spanning Tree mode to Rapid Spanning Tree.
>> /cfg/l2/mrst
>> Multiple Spanning Tree# mode rstp
>> Multiple Spanning Tree# on
4. Configure STP Group 1 parameters.
>> /cfg/l2/stg 1
>> Spanning Tree Group 1# add 2
>> Spanning Tree Group 1# apply
120 Chapter 6: Rapid Spanning Tree Protocol/Multiple Spanning Tree Protocol
(Select Spanning Tree Group 2)
(Clear STP Group 2 parameters)
(Turn off STP Group 2)
(Select Multiple Spanning Tree menu)
(Set mode to Rapid Spanning Tree)
(Turn Rapid Spanning Tree on)
(Select Spanning Tree Protocol menu)
(Add VLAN 2 STP Group 1)
(Apply the configurations)
42C4911, January 2007