Configuring Provider Interface Settings - Polycom V2IU 6400-S User Manual

2
User Guide V IU 6400-S Converged Network Appliance
Note

Configuring provider interface settings

4 - 2
To configure subscriber interface settings:
1. In the navigation bar, select Network.
2. In Subscriber Interface Settings, highlight and replace the default IP
Address and Subnet Mask.
3. If you are configuring network settings, see the instructions in
Configuring the Network
4. If you want to configure a management interface that is different than the
default, complete all of the configuration tasks, then see
management interface
5. Press Submit.
After submitting the new configurations, you need to reconnect to the 6400-S using
the new IP address and subnet mask before you can continue with the
configuration.
The provider interface defines the interface between the 6400-S and internal
voice, video and data devices. This interface is generally connected to the
private network.
\
on page 4-5.
on page 7-9.
Configuring a