Installation Guidelines - Siemens SCALANCE X-400 Operating Instructions Manual

Directive on Machines
The product remains a component in compliance with Article 4 (2) of the EU direc-
tive on machines 89/392/EEC.
According to the directive on machines, we are obliged to point out that the product
described is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it
conforms with the directive 89/392/EEC.
Note for the Manufacturers of Machines
This product is not a machine in the sense of the EU directive on machines. There
is therefore no declaration of conformity for the EU directive on machines
89/392/EEC.
If the product is part of the equipment of a machine, it must be included in the pro-
cedure for obtaining the declaration of conformity by the manufacture of the ma-
chine.

Installation Guidelines

The products meet the requirements if you adhere to the installation and safety in-
structions contained in these Operating Instructions SIMATIC NET Industrial
Ethernet SCALANCE X-400 and in the following documentation:
SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual /2/
This documentation is available on the Internet at
http://support.automation.siemens.com/WW/view/en/8763736
Warning
!
Personal injury and damage to property may occur.
The installation of expansions that are not approved for SIMATIC NET products or
their target systems may violate the requirements and regulations for safety and
electromagnetic compatibility.
Only use expansions that are approved for the system.
Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches
C79000-G8976-C186-03
Approvals, Certificates
133