Canon MG5100 series On-Screen Manual page 112

> Routine Maintenance
Contents
C099
Cleaning the Paper Feed Roller
If the Paper Feed Roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the Paper Feed Roller. Cleaning will wear out the Paper Feed Roller, so perform this
only when necessary.
You need to prepare: three sheets of A4 or Letter-sized plain paper
1.
Make sure that the power is turned on.
2.
Open the Paper Output Tray gently, and open the Output Tray Extension.
3.
Select Roller cleaning.
Select Setup
(1)
Selecting Menus on the HOME Screen
See
The Setup menu screen will appear.
(2) Select Maintenance
The Maintenance screen will appear.
Select Roller cleaning, and press the
(3)
The confirmation screen will appear.
Select Yes, and press the
(4)
Select the paper source to clean (Rear tray or Cassette), and press the
(5)
button.
4.
Clean the Paper Feed Roller without paper.
Follow the message to remove paper in the paper source you selected in (5) of
(1)
step 3.
Press the OK button.
(2)
The Paper Feed Roller will rotate as it is cleaned.
5.
Clean the Paper Feed Roller with paper.
(1) Make sure that the Paper Feed Roller has stopped rotating, then follow the
message to load three or more sheets of A4 or Letter-sized plain paper in the
paper source you selected in (5) of step 3.
(2) Press the OK button.
The machine starts cleaning. The cleaning will be completed after the paper is ejected.
When the completion message appears, press the
(3)
The screen will return to the Maintenance screen.
> Cleaning the Paper Feed Roller
on the HOME screen.
.
, and press the OK button.
OK
button.
OK
Advanced Guide
button.
button.
OK
Troubleshooting
OK