Error Messages - Brother P-touch PT-2030 User Manual

When an error message appears on the display, follow the directions provided below.
Message
Battery Weak! *
Check
Battery!
Wrong Type
Of Adapter
Connected!
Cutter Error! *
No Text! *
Insert Tape
Cassette! *
Line Limit!
Max 5 Lines *
Tape Width
Limit!
Max 3 Lines *
Tape Width
Limit!
Max 2 Lines *
Tape Width
Limit!
Max 1 Line *
Block Limit!
Max 5 Blocks *
Text Full! *
Length Limit! *
*Press any key to clear the error message.

Error Messages

The installed batteries are getting weak.
The installed batteries are about to run out of power. Replace
with new batteries or connect the AC adapter before continuing.
An incompatible AC adapter is connected. After the power is
turned off automatically, use the AC adapter designed
exclusively for your P-touch labeler.
The tape cutter is closed when you try to print or feed tape. Turn
the P-touch labeler off and then on again before continuing.
When tape is tangled in the cutter, remove the tape.
There is no text, symbols or bar code data entered when you try
to print or preview a label. Enter data before continuing.
There is no tape cassette installed when you try to print or
preview a label, or feed tape. Install a tape cassette before
continuing.
There are already five lines of text when you press the
Enter key. Limit the number of lines to five.
There are more than three lines of text when you press the Print
or Preview key while using 12 mm tape. Limit the number of lines
to three, or replace with a larger width tape cassette.
There are more than two lines of text when you press the Print
or Preview key while using 9 mm or 6 mm tape. Limit the number
of lines to two, or replace with a larger width tape cassette.
There is more than one line of text when you press the Print or
Preview key while using 3.5mm tape. Limit the number of lines
to one, or replace with a larger width tape cassette.
There are already five blocks of text. Limit the number of blocks
to five.
The maximum number of characters have already been entered.
Edit the text and use fewer characters.
The length of the label to be printed using the text entered is
longer than 1 m. Edit the text so that the length of the label is less
than 1 m.
Cause/Remedy
1
2
3
4
5
6
7
8
9
56
Error Messages