Error And Maintenance Messages - Brother PT-D410 User Manual

Home > Troubleshooting

Error and Maintenance Messages

>> PT-D410
>> PT-D460BT
PT-D410
Message
Check no. of digits
entered
Cutter error
Length limit
System error XX
Text too long
PT-D460BT
Message
Check no. of digits
entered
Cutter malfunction
Label too long
System error XX
Text too long
Related Information
• Troubleshooting
> Error and Maintenance Messages
Cause/Remedy
The number of digits entered in the barcode data does not match the number of digits
set in the barcode parameters. Enter the correct number of digits.
The Tape Cutter Lever was pressed while trying to print or feed the tape. If the tape is
jammed in the Cutter unit, remove the tape. Turn the Label Printer off and then on again
before continuing.
The printed label length using the text entered is longer than 999 mm. Edit the text so
that the label length is less than 999 mm.
Contact Brother customer service.
The printed label length using the text entered is longer than the length setting. Edit the
text to fit within the set length or change the length setting.
Cause/Remedy
The number of digits entered in the barcode data does not match the number of digits
set in the barcode parameters. Enter the correct number of digits.
If the tape is jammed in the Cutter unit, remove the tape. Turn the Label Printer off and
then on again before continuing.
The printed label length using the text entered is longer than 999 mm. Edit the text so
that the label length is less than 999 mm.
Contact Brother customer service.
The printed label length using the text entered is longer than the length setting. Edit the
text to fit within the set length or change the length setting.
108