Table of Contents
Advertisement
When an error message appears on the display, follow the directions provided below.
Wrong Type
Of Adapter
Connected!
Low Battery!
Replace Battery!
Recharge
Li-ion Battery!
Li-ion is damaged
Use other
power source!
Unit Cooling
Wait XX min.
before restart!
Cutter Error!
Insert Tape
Cassette!
Text Full!
No Text!
Incorrect
Value!
Line Limit!
Max 5 Lines
Tape Width
Limit!
Max 3 Lines
Tape Width
Limit!
Max 2 Lines
Tape Width
Limit!
Max 1 Line
Block Limit!
Max 5 Blocks
Length Limit!
Text
Too Long!
1.888.610.7664
Error Messages
Message
An incompatible AC adapter is connected.
Use an appropriate AC adapter.
The installed batteries are getting weak.
The installed batteries are about to run out.
The battery is low. Please charge the lithium-ion battery.
The Li-ion is damaged. Please use an AC adapter or an other battery.
High temperature error.
The tape cutter has been closed when you tried to print or feed tape. Turn
the P-touch labelling system off and then on again before continuing. When
tape is tangled in the cutter, remove the tape.
There is no tape cassette installed when you try to print or preview a label,
or feed tape. Install a tape cassette before continuing.
The maximum number of characters have already been entered. Edit the
text and use fewer characters.
There is no text, symbols or bar code data entered when you try to print or
preview a label. Enter data before continuing.
The value entered for setting the tape length. Enter a valid value for the
setting.
There are already five lines of text when you press the Enter key. Limit the
number of lines to five.
There are more than three lines of text when you press the Print or Preview
key while using 12 mm tape. Limit the number of lines to three, or replace
with a larger width tape cassette.
There are more than two lines of text when you press the Print or Preview
key while using 9 mm or 6 mm tape. Limit the number of lines to two, or
replace with a larger width tape cassette.
There is more than one line of text when you press the Print or Preview key
while using 3.5 mm tape. Limit the number of lines to one, or replace with
a larger width tape cassette.
There are already five blocks of text. Limit the number of blocks to five.
The length of the label to be printed using the text entered is longer than
1 m. Edit the text so that the length of the label is less than 1 m.
The length of the label to be printed using the text entered is longer than
the length setting. Edit the text to fit within the set length or change the
length setting.
www.calcert.com
15
10
20
5
25
0
30
Cause/Remedy
1
2
3
4
5
6
7
8
9
48
Error Messages
sales@calcert.com
Advertisement
Table of Contents
