Color Modes; Using Simple Color Mode - Set Simple Color - Brother HL-1050 Technical Reference Manual

8/2/2010
2.

COLOR MODES

The PCL5C emulation provides a B/W mode, which is the default, and three color modes as follows;
1) Simple Color Mode
2) PCL Color Mode
3) HP-GL/2 Color Mode
Simple Color Mode allows you to use a maximum of 8 colors easily. PCL Color Mode allows you to use a
maximum of 16,000,000 colors logically. HP-GL/2 Mode allows you to use vector graphics in color.
It is possible to switch between these modes in a single page, which enables you to use each of them for your
purpose.
When handling colors in those modes, use palette. For details on palette, refer to Section 3 'Color Palettes' of
this chapter.
This section describes the details about each color mode.
2.1.

Using Simple Color Mode - Set Simple Color

Command
ESC*r#U (27)(42)(114)#(85) <1Bh><2Ah><72h>#<55h>
# = -4
# = -3
# = 1
*
# = 3
* Default value = 1
The # value specifies the palette and the colors for the palette. For specific colors, refer to the table below;
This command specifies each color corresponding to the index number. The color is fixed and
unchangeable.
The colors which were specified in the palette by the PCL or HP-GL/2 command are cancelled.
Index No
* = default
CMYK mode
CMY mode
B/W mode
RGB mode
-4 (CMYK)
0 White
1 Cyan
2 Magenta
3 Blue
4 Yellow
5 Green
6 Red
7 Black
-3(CMY)
White
Cyan
Magenta
Blue
Yellow
Green
Red
Black
CHAPTER 3 "PCL5C" - 4
1(B/W) * 3(RGB)
White
Black
-
-
-
- Magenta
-
-
Black
Red
Green
Yellow
Blue
Cyan
White