Registration - Binatone Concept Combo 3525 Twin User Manual

REGISTRATION

8
IMPORTANT: When you purchase your phone system, all cordless
handsets are already registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra cordless or if a
cordless has become faulty.
You can register additional cordless to have up to 5 handsets per base unit,
with each handset's number (1 to 5) shown on its display.
A cordless handset can be registered to only one base at a time.
To check whether a handset is registered, make sure mains power to the
base unit is switched on and the handset is within range. The handset's
display should show its number and the <Antenna icon> should be steadily
on. If the display shows
again using the following process:
1. On the base station, press <MENU/OK> and <UP/DOWN> to show
REGISTRATION, and then press <MENU/OK> to put the base station into
registration mode. The base display will show "PLEASE WAIT" and the
base will stay in registration mode for about 2 minute, so the following
handset sequence must be completed within this time.
2. Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
3. Press <MENU/OK> to display PIN?----.
4. Enter the 4-digit system PIN (default is 0000).
5. Press <MENU/OK> to confirm, and the display will show
PLEASE WAIT flashing.
If the handset registration is successful, the display will change to standby
mode with the new handset number and the <antenna icon> will stop flashing.
The handset will automatically be allocated the next available handset
number. If the handset registration is unsuccessful, the <antenna icon> will
still flash.
"REGISTER ", you need to register the handset
47