Table of Contents
Advertisement
End a Call
4.12
During a call connection, put the corded handset on the base station to end
the call.
Or press <SPEAKERPHONE> if you have a call in handsfree mode.
Adjust Earpiece and Handsfree Volume
4.13
There are 5 levels (VOLUME 1 to VOLUME 5) to choose from for each of
the earpiece and speaker volumes.
During a call:
Press <UP/DOWN> to increase or decrease the volume level respectively.
The current setting is shown. When you end the call, the settings will remain
at the last selected level.
4.14
Mute a Call
You can talk to someone nearby without letting the caller hear you during a
call.
During a call:
Press <C/MUTE> to mute the microphone and "MUTED " is displayed on
the display. Your caller cannot hear you. Press <C/MUTE> again to
unmute the microphone.
the display, and the caller will be able to hear you again.
4.15
Emergency Call without Mains Power
The corded base unit can make an emergency call with the corded handset
when the mains AC power is disconnected.
Pick up the corded handset and wait for several seconds to get the dial tone
and then enter the phone number to make a call.
Note: It is not possible to dial numbers from memories or use the
speakerphone when the mains power is off.
When the mains power is off, you can also answer an incoming call
with the corded handset.
When the phone rings, pick up the corded handset to talk to the caller
after a few seconds.
"MUTED" will be replaced by
25
on
"LINE IN USE"
Hide quick links:
Advertisement
Table of Contents
