How To Insert/Replace The Batteries; Battery Status Display; How To Set The Gain; How To Turn The Transmitter On/Off - Beyerdynamic Synexis Operating Instructions Manual

Synexis – Synexis TH2 Handheld Transmitter
3.2

How to insert/replace the batteries

• Slide down the lid to open the battery compartment
• Insert the supplied NiMH rechargeable batteries according to the polarity marks.
Before using the transmitter for the first time, the rechargeable batteries inside
must be charged e.g. with the Synexis C8 charger. As an alternative you can use
two 1.5 V AA alkaline batteries.
• Close the battery compartment
3.3

Battery status display

• The battery status is displayed
• If only one bar is displayed, you should recharge the receiver as soon as possible.
• If the battery frame is flashing, the batteries are empty and have to be replaced or
recharged.
• If the transmitter is equipped with rechargeable NiMH batteries, put it into the
appropriate charger (e.g. Synexis C8). Despite the Auto-Off function we
recommend turning off the transmitter before charging.
Depending on the charger, the LED of the charger or the LED
charging status:
LED is flashing blue . . . . . . . . . . The batteries are being charged
LED illuminates blue. . . . . . . . . . The batteries are fully charged
LED is flashing red . . . . . . . . . . . Error
3.4

How to set the gain

• Inside the battery compartment
gain for close or distant miking. Remove the batteries first and then set the gain.
Position "High" = set switch to "H"
Position "Low" = set switch to "L"
3.5

How to turn the transmitter on/off

• Turn on the handheld transmitter by pressing the on/off button
3 seconds.
• The battery status, selected channel and mute function are displayed
• After use turn off the handheld transmitter by pressing the on/off button
approx. 3 seconds.
.
by sliding the lid to the top.
in 4 stages.
indicates the
you will find the gain switch to set the
for approx.
.
for
10