Default Serial Parameters; Default Ip Address - Barco MatrixPRO User Manual

_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä

Default Serial Parameters

aÉÑ~ìäí=pÉêá~ä=m~ê~ãÉíÉêë
The following are the parameter settings for serial communication:
•
•
•
•
•
•
aÉÑ~ìäí=fm=^ÇÇêÉëë
The MatrixPRO default IP address is 192.168.000.243.
Please note:
•
•
92
Baud Rate = 115K baud
Parity = NONE
Stop Bit = 1
Data Bit = 8
Echo = ON
Flow Control = NONE
Note These are the default settings, but only the baud rate can be
changed serially, or using the menu. In Chapter 4, refer to the
"RS-232 Settings
The system returns to this value after a factory reset.
This default address can be changed using the menu system. In Chapter 4, refer
to the "IP Address" section on page 37 for instructions.
Menu" section on page 37 for instructions.
MatrixPRO • 8x8 DVI Router • User's Guide