Barco MatrixPRO User Manual page 81

9.
R S - 2 3 2 S E T T I N G S
> Bau d Rate
Figure 6-2. MatrixPRO RS-232 Settings Menu
10. To upload files to MatrixPRO, click "Open script file to read and upload."
11. In the dialog, select "Complete_Load.sld" and click Open. The MatrixPRO menu
12. It takes several minutes to load the flash memory. When complete, the Flash
13. Cycle power on the MatrixPRO, and exit the Flash Loader utility.
14. On MatrixPRO, perform a factory reset. In Chapter 4, refer to the
15. On MatrixPRO, verify that the new software has been loaded correctly. In
This completes the software upgrade procedure via serial communications.
MatrixPRO • 8x8 DVI Router • User's Guide
e. If the prompt appears, continue with step 10 (uploading files).
To troubleshoot the serial connection:
a. If the DCD and CTS status lights are green, re-check the communication
settings in the loader, and verify that the COM port and Baud Rate
settings are correct.
b. To verify MatrixPRO communication settings, using the MatrixPRO
menu, select SETUP to display the Setup Menu.
c. From the System Menu, select
232 Settings Menu.
Par ameter s
d. Ensure that the baud rate is set to 115200. Other parameters cannot be
changed.
e. Repeat steps 7 and 8 above, then re-check the status lights.
f. With communication status OK, continue with step 10.
should immediately display the "System in LOADER MODE" message.
Loader utility displays the "Upload Complete" message. Click OK to continue.
Menu" section on page 39 for instructions.
Chapter 4, refer to the "Tech Support
6. Upgrading Software
Serial Upgrade Method
RS-232 Settings
to display the RS-
115 200
[N8 1]
Menu" section on page 39 for instructions.
"Factory Reset
81