Pairing The Device - Aztech 500Mbps 4-Port HomePlugAV Ethernet Adaptor User Manual

Pairing the Device

Your HomePlugAV devices by default are preconfigured to have a common Private
Network Name. Setting up your HomePlugAV network is as easy as 1,2 and 3.
1. Plug in your HomePlugAV devices side by side to easily observe the LED behavior.
Wait until the Power and PL-ACT LED turns ON to confirm that the connection has
been established.
2. In Location A plug in your HomePlugAV into the power outlet then connect it to
your Modem/Router's Ethernet LAN port using an Ethernet cable.
3. In Location B connect the power cable of your 4-Port HomePlugAV then plug it
into the power socket. Connect your Ethernet devices with an Ethernet cable. Your
HomePlugAV is now ready to use.
User Manual
Page 9 of 42