Pairing The Device - Aztech 200Mbps HomePlug AV Ethernet Adaptor User Manual

Pairing the Device

Your HomePlug AV devices by default are preconfigured to have a common Private
Network Name. Setting up your HomePlugAV network is as easy as 1,2 and 3.
1. Plug in your HomePlugAV devices side by side to easily observe the LED behavior.
Wait until the Power and PL-ACT LED turns ON to confirm that the connection has
been established.
2. In Room A plug in your HomePlugAV X into the wall socket then connect it to your
Modem/Router's Ethernet LAN port using an Ethernet cable.
3. In Room B plug in your HomePlugAV into the wall socket then connect it to your
computer's Ethernet Port. Your HomePlugAV is now ready to use.
User Manual
Page 9 of 42