Table of Contents
Advertisement
Maintenance
WARNING! DISCONNECT THE
MACHINE FROM THE MAINS
SUPPLY BEFORE CONTINUING!
Cleaning
Excessive dust in the motor can cause excessive heat
to develop. Every effort should be made to prevent
foreign material from entering the motor.
When operated under conditions likely to permit
accumulations of dust, dirt or waste, a visual
inspection should be made at frequent intervals.
Accumulations of dry dust can usually be blown out
successfully.
Caution: To avoid eye injury or adverse reaction
to dust, high pressure hoses should not be used
especially in poorly ventilated areas. The operator
performing this cleaning function should wear
safety goggles and dust filter mask.
After cleaning all dust and debris a light coating of
machine oil on the quill then to spread the oil.
If the machine is going to stand idle for any length
of time, a light coat of spray or machine oil over the
column and table will prevent rusting.
Electrics
WARNING! DO NOT USE THE
MACHINE IF THE POWER CABLE
HAS BECOME DAMAGED
If any servicing (other than the above cleaning)
becomes necessary the unit should be returned
to Axminster tool centre to be repaired by one of
our qualified electrician. Contact our technical sales
department for further assistance.
Call 03332 406406
Email technical@axminster.co.uk
WARNING! DO NOT ATTEMPED TO
REPAIR IT YOUR SELF CONTACT
OUR TECHNICAL SALES TEAM FOR
ASSSISTANCE!
Motor speed
The speed of the motor cannot be regulated or
changed - no adjustment is necessary.
Oiling points
24
Hide quick links:
Advertisement
Table of Contents
