Axminster Pillar Drills User Manual page 11

Fig 14
WARNING! THE DRILLHEAD IS A
HEAVY AND SUBSTANTIAL PIECE
OF MACHINERY, YOU ARE ADVISED
TO HAVE HELP TO LIFT IT CLEAR
OF THE BOx AND FIT IT TO THE
COLUMN.
Fig 15
6
Fig 16
1
Raised boss
Spigot
Phillips screw
Fit the guard assembly to the lower bearing flange of
the quill mounting, tighten the screw and nut so that
the drill guard is securely held in place.
Morse taper arbor and chuck
Locate the morse taper arbor (11) and the B16 keyless
chuck (13). Insert the arbor into the keyless chuck as
shown in (fig 20). Insert the other end of the arbor
(11) up into the lower bearing flange in the quill until
the assembly locks in place, (see fig 21)
11
Assembly
Fig 17-18
7
Fig 19
Continues Over...