Maintenance - Axminster AC285PD User Manual

Maintenance

WARNING! DISCONNECT THE MACHINE FROM THE
MAINS SUPPLY BEFORE CONTINUING!
Cleaning
Excessive dust in the motor can cause heat to develop.
Every effort should be made to prevent foreign material
from entering the motor.
Where you may find accumulations of dust, dirt or waste,
a visual inspection should be made at frequent intervals.
Accumulations of dry dust can usually be blown out.
Caution: To avoid eye injury or adverse reaction to dust,
high pressure hoses should not be used especially in
poorly ventilated areas.
After cleaning apply a light coat of machine oil on the quill
and chuck.
If the machine is going to stand idle for any length of time, a
light coat of spray or machine oil over the column and table
will prevent rusting. Place a dust sheet over the drill.
Electric
WARNING! DO NOT USE THE MACHINE IF THE
POWER CABLE HAS BECOME DAMAGED
If any servicing (other than the cleaning above) becomes
necessary, the unit should be returned to Axminster Tool Centre
for repair by one of our qualified electricians. Contact our
customer sales department for further assisance on:
Call: 03332 406406
(+44 1297 302377)
Email: cs@axminster.co.uk
WARNING! DO NOT ATTEMPED TO REPAIR IT
YOURSELF CONTACT OUR TECHNICAL SALES TEAM
FOR ASSISTANCE!
Motor speed
The speed of the motor cannot be regulated or changed - no
adjustment is necessary.
Oil Points
20