Adjusting The Spindle Speed; Routine Maintenance - Axminster D.R.O. Micro Drill User Manual

Hide thumbs

Table Of Contents

Table of Contents

Fig 6

Loosen and remove the two

screws on the belt cover.

Fig 7

Remove the belt cover.

WARNING!!

Excessive dust in the motor can cause excessive heat to develop. Every effort should be

made to prevent foreign material from entering the motor. When operated under conditions

likely to permit accumulations of dust, dirt or waste, a visual inspection should be made at

frequent intervals.

Accumulations of dry dust can usually be blown out successfully.

Caution:

To avoid eye injury or adverse reaction to dust, high pressure hoses

should not be used especially in poorly ventilated areas. The operator performing this

cleaning function should wear safety goggles and dust filter mask.

After cleaning all dust and debris, a light coating of machine oil or spray oil on the quill then

exercising to spread the oil all over.

If the machine is going to stand idle for any length of time, a light coat of spray or machine

oil over the column and table will prevent rusting.

Do not use the machine if the power cable has become damaged.

If any servicing (other than the above cleaning) becomes necessary the unit should be

returned to your supplier or repaired by a qualified electrician.