Axminster Pillar Drills User Manual page 13

Fig 25-26
Line up the three pre-drilled holes and secure with
the Phillips screws
Keyless chuck
Insert the keyless chuck (13) over the morse taper
arbor as shown in (fig 27) and press home.
Fig 27
Lever feed handles
Locate the three lever handles (14) and screw them
into the threaded holes on the feed shaft, (See fig 28)
Guard moulding
Guard shield
Pre-drilled hole
13
Pillar drill head
WARNING! THE DRILLHEAD IS A
HEAVY AND SUBSTANTIAL PIECE
OF MACHINERY, YOU ARE ADVISED
TO HAVE HELP!
Using the 3mm Hex key loosen the two grub screws
to the right side of the head, (see fig 29) lift the drill
head above the column and let it drop into place.
Fig 29
Set the drillhead approximately fore and aft and
lock in position using the two caphead grub screws
mentioned earlier.
Check that the drillhead is immobile. Everything on
the drilling machine is now secured, and if you now
wish to move it to its preferred workplace, nothing
should slew during the lift and move. Once the
drilling machine is correctly positioned and fastened
down, it is ready for use.
13
Assembly
Fig 28
14