11/07 Rev. 4.03-01
1. Turn off the printer.
2. Turn on the power. Press and hold the CANCEL button.
3. Ribbon indicator blinks, release the button.
USER MANUAL
Performing a Factory Reset
If you would like to reset the printer to its factory defaults after certain com-
mands have been sent or settings changed:
Ribbon indicator stops blinking and lights up.
The following parameters automatically reset.
– Label parameters
– Heat(Darkness)
– Speed
– Symbol set (language)
– Others for specific interpreter
All settings stored in non-volatile E
turning the printer off.
It is necessary to perform label sensitivity calibration after resetting.
The printed label count can not be reset.
AP 3.4
2
PROM cannot be destroyed even by
Commissioning and Operation
8