Connecting The Printer - Avery Dennison AP3.4 User Manual

11/07 Rev. 4.03-01
1. Leave the power switch [1A] at the "O" Position.
2. Connect the power supply plug to the power jack [1E] and the other end of
3. Connect the printer with any standard Centronics cable to the parallel port of
USER MANUAL

Connecting the printer

WARNING!
Printer is driven by mains voltage! Touching of live parts can cause life-
threatening body currents and burns!
Make sure, that the printer is switched off, before connecting the power ca-
ble.
Only connect the printer to a power socket that provides the correct voltage,
which can be found on the rating plate.
Only connect the printer to a grounded power socket fitted to authorized
standards.
When laying the power supply cable, ensure that:
– no one can trip over it.
– no one can step on it.
– the power supply cable can be pulled out of the power outlet, if
necessary.
the cord to your AC outlet [1F].
the host computer and to the Centronics connector [1C] of the printer.
Alternatively, you can connect the printer as follows:
– With a serial cable to the RS232C port of your computer.
– With a USB cable to the USB port of your computer.
AP 3.4
Commissioning and Operation
3