Horizon Fitness CLUB E500 User Manual page 6

AS SE MB LY ST EP 
NOTE: There is NO hardware bag for this step.
A) Slide LOWER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure LOWER HANDLEBAR to CONSOLE MAST using
PRE-ATTACHED SET SCREWS.
B) Slide UPPER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure UPPER HANDLEBAR to CONSOLE MAST using PRE-ATTACHED SET SCREWS.
C) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
WARNING
machine is fully assembled, do not grab the handlebars for support.
10
E500-E800_Rev.1.7.indd 10-11
NOTCH UPPER HANDLEBAR
PRE-ATTACHED SCREWS
TAB
HANDLEBAR JOINT
LOWER HANDLEBAR
ASSEMBLY STEP 5
SCREW (E)
E800 SHOWN
A) Open HARDWARE BAG FOR STEP 5.
B) Attach FOOTPAD to LOWER LINK ARM using 4 SCREWS (E).
C) Repeat on other side.
C) 29mm wave washer
HARDWARE BAG FOR STEP 5 CONTENTS : A) M5x20mm Screw
quantity: 2
quantity:4
B) M5x15mm Screw
D) M8x15mm Screw
quantity:8
quantity:6
SCREW (E)
20 mm
Qty: 4
FOOTPAD
LOWER LINK ARM
SCREW (E)
15 mm
Qty: 8
SCREW (H)
SCREW (G)
15 mm
29 mm
Qty: 2
Qty: 6
11
4/27/07 1:43:50 PM