Dip-Switch With Link Mode; Led Indicators - Planet FGSW-008 User Manual

3-3-2 DIP-Switch with Link Mode

An ST/SC/MT-RJ/VF-45 connector provides the link to the
multi-mode fiber or single mode fiber cabling, and two LED
indicators show the status of the Module at a glance. A DIP-switch
sets the operating mode to half-duplex or full-duplex ( default ).
ON
OFF
Figure 3-5. DIP-switch location and setting mode of FGSW-4ST/4SC
The following Table lists the port's operating modes based on the
DIP- switch position.
ON Half-Duplex
OFF Full-Duplex

3-3-3 LED Indicators

There are two LED indicators for each of the Fiber connection ports.
If there is no connection to a port, the corresponding LED indicators
are not lit.
FGSW-008 User's Manual
11