Table of Contents
Advertisement
2. Place the Switch on a flat surface. Grasp the thumbscrew
on the sides of the optional module or blank bracket and
turn counter- clockwise to unscrew them. You can also use
a screwdriver. Remove the old module or the blank
bracket and set aside. Do not discard the module or blank
bracket. Put the module or blank bracket back in if you
remove the new module.
3. Install the new module by inserting it into the guides and
sliding it in until it stops ( See Figure 3-12 ). Press it
firmly until you feel the module snap into place. Never
force, twist or bend the optional module. The optional
module slides in smoothly.
4. Gently push the thumbscrews in and turn clockwise to
tighten. Do not over tighten the thumbscrews.
5. Power the Switch on after you have installed the new
module. The Switch will auto detect the new module.
6. Take off the dust cover from the transceiver and plug the
cable in, if you are installing a fiber optic or gigabit
module.
7. Check the LEDs to verify that if there is a link and a
FGSW-008 User's Manual
Figure 3-12. Insert the modules
19
Advertisement
Table of Contents
