Advertisement
1
2
Before first use
1
Remove all packaging material from the water purifier and the filters.
2
Clean the raw water tank and the clean water tank with hot water.
inserting the Pure protect alert display battery
1
Remove the battery compartment cover on the inside of the top
cover with a coin.
2
Put the 3-volt CR2032 Lithium battery supplied in the battery
compartment. You find this battery in the accessory bag.
Note: The Pure protect alert display works on this battery.
3
Put the cover back onto the battery compartment and tighten it
with a coin.
Attaching the adapter to the clean water tank
Note: Place and use the water purifier and your dispenser on a stable, level
and horizontal surface.
1
Take the 4 adapter parts out of their packaging.
2
Put the float pin in the hole of the support plate from the top. The
threaded part of the pin has to point downwards. Push the pin down
completely, so that the threaded parts sticks out from the bottom of
the support plate.
3
Screw the float body onto the float pin.
4
Place the support plate underneath the clean water tank. The float
body has to point downwards.
English
9
Advertisement
