Advertisement
English
14
Note: To reset the Pure protect alert display, press the display activation/reset
button for 3 seconds. When the display has been reset successfully, the display
flashes 3 times. Then the filter replacement symbol disappears and the
display shows all segments of the progress bar again.
how the Pure protect alert display works
The Pure protect alert display is equipped with a counter that calculates
how much water you filter. The counter bases its calculation on the
assumption that you fill the water tank when it is completely empty and
that you fill it with approx. 5 litres of water. For extra health protection, the
counter also counts the number of days you have used the Long-life filter.
The progress bar decreases in length as time passes. The filter replacement
symbol appears 163 days after the first day of use. It flashes with two arrows
when the filter has been used for 182 days in total*.
*Calculation based on a 4-person family with a daily water consumption of
4-6 litres. The Long-life filter lasts up to 6 months with a maximum lifetime
of 1000 litres.
-
To save energy, the Pure protect alert display automatically goes out
1 minute after you have closed the lid. It lights up automatically when
you open the lid. Alternatively, you can also press the display activation/
reset button once to activate the display.
-
When the battery of the Pure protect alert display is almost empty,
the battery symbol flashes on the display.
-
When the display shows the battery symbol, you have to replace the
old battery with a new 3-volt CR2032 Lithium battery. See section
'Replacing the battery of the Pure protect alert display' in chapter
'Replacement'.
Cleaning and maintenance
Only the outside of the water purifier and the rust & sediment pre-filter
can be cleaned with hot water and a mild cleaning agent. The Long-life filter
cannot be cleaned but has to be replaced (see chapter 'Replacement').
The Soft water booster (WP3853 only) cannot be cleaned but has to be
regenerated (see section 'Regenerating the Soft water booster (WP3853
only)' in this chapter) and ultimately replaced.
Never use scouring pads, detergents, abrasive cleaning agents or aggressive
fluids such as thinner, alcohol, petrol or acetone to clean the outside of
the water purifier. These substances may cause the material of the water
purifier to crack, discolour or distort. Do not clean any part of the water
purifier in a dishwasher or with boiling water.
Do not use a kitchen sponge or cloth to clean or dry the inside of the
water tanks because they are likely to contain bacteria. To clean the
water tanks in a hygienic way, follow the cleaning instructions below.
Advertisement
