Advertisement
English
10
1
2
5
Insert the bolt into the hole on the inside of the clean water tank
and tighten it with a coin.
Make sure you disinfect the coin before you use it to tighten the bolt in
the clean water tank.
Tip: You can disinfect the coin by first cleaning it with detergent, rinsing it with
clean water and then putting it in boiling water for at least 10 minutes.
, The support plate with float unit is now attached to the bottom of
the clean water tank.
6
Clean the clean water tank (with the adapter attached) with clean
water.
Tip: You can use hot water to clean the clean water tank.
7
Place the clean water tank on top of the dispenser you want to use.
Installing the filters
1
Remove the protection cap from the Long-life filter.
Note: Be careful not to detach the sealing ring of the Long-life filter.
Note: Some carbon particles may come out of the Long-life filter and end up in
the raw water tank. This is normal and does not pose any health risks. You can
simply clean the raw water tank to remove the carbon particles.
2
Insert the top of the Long-life filter into the bottom of the raw
water tank (1) and turn it to the right to fix it (2).
3
WP3853 only: Push the Soft water booster into the raw water tank
('click').
Note: The Soft water booster is moist when you unpack it. This is normal
because the Soft water booster must be kept moist to ensure its effectiveness.
Note: The inside of the Soft water booster changes colour when it becomes wet.
This is normal.
4
Place the raw water tank on the clean water tank.
Always make sure the Soft water booster (WP3853 only) and the Long-life
filter are attached to the raw water tank.
Advertisement
