Advertisement
-
When 50% of the filter capacity has been used, the display shows
2 segments of the progress bar.
-
When 75% of the filter capacity has been used, the display shows
1 segment of the progress bar.
-
When 90% of the filter capacity has been used, the display shows
1 segment of the progress bar and the filter replacement symbol. Make
sure you have a new Long-life filter available at this time. If you want,
you can replace the Long-life filter with a new one and reset the
display so that the filter capacity does not reach 0%.
Note: To reset the Pure protect alert display, press the display activation/reset
button for 3 seconds. When the display has been reset successfully, the display
flashes 3 times. Then the filter replacement symbol disappears and the display
shows all segments of the progress bar again.
-
When the filter capacity reaches 0%, the filter replacement symbol and
two arrows flash. When this happens, you MUST replace the Long-life
filter immediately. After you have replaced this filter, reset the display.
English
13
Advertisement
