Ethernet Specifications - Patton electronics 1088/I User Manual

10baset mdsl rocket

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

If the above test indicates no errors are present, move the

test switch V.52 toggle switch UP, activating the "511/E"

test with intentional errors present. If the test is working prop

erly, the local unit's red "ER" LED will blink. A successful

"511/E" test will confirm that the link is in place, and that the

Model 1088's built-in "511" generator and detector are work

ing properly.

APPENDIX A

PATTON ELECTRONICS 10BASE-T MDSL ROCKET

SPECIFICATIONS

Clocking Modes:

Internal or Receive Recovered

DTE Rate:

All 64k increments from 64 to 2304 kbps

Diagnostics:

V52 compliant (511/511E) pattern generator

and detector with error injection mode and

Remote Loopback control by a single front

panel switch

LED Status:

The following LEDs are displayed on the

front panel:

DSL Link (Green Active) - DSL Link Active

10BT Link (Green Active) - Valid Ethernet

Connection

Status (Flashing Yellow) - Status indica-

tion from the Ethernet port

NS (Red Active) - No signal on DSP Link

ER (Flashing Red) - CRC error during nor-

mal operation, bit error during pattern gen-

eration test

TM (Active Yellow) - Test Mode Enabled

Configuration:

Externally accessible dip switches or

SNMP/HTTP managed through 1095RC

Power:

+5V External desk top power supply, 100-

240VAC, 50-60 Hz (Universal Input), 10W

or -48 VDC

Compliance:

FCC Part 15, CE mark

Transmission Line:

Single Twisted Pair (2 wires)

Line Coding:

CAP (Carrierless Amplitude and Phase

Modulation)

Line Rates (DSL line):

144, 272, 400, 528, 784, 1040, 1552, 2064,

2320 kbps

Line Interface:

Transformer coupled, 1500 VAC isolation

mDSL Physical