Table of Contents
Advertisement
3.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE
CAUTION
The RJ-45 ports labeled Ethernet are the Auto-MDIX10/100Base-T inter-
faces. These ports are designed to connect directly to a 10/100Base-T
device, network, hub or PC using either a straight or crossover cable that
is up to 328ft long. Figure 5 shows the signal/pin relationships on this
interface.
Figure 5. Model 1069 10/100Base-T RJ-45 Connector Pinout.
3.3 CONNECTING THE POTS/ISDN LINE
The RJ-45 port labeled POTS/ISDN is the POTS/ISDN interface. A tele-
phone or an ISDN device may be connected to this port and carried over
the VDSL2 line. The units do not need power for the POTS interface to
work. The RJ-45 connector in the Model 1069's POTS/ISDN interface is
wired as shown in Figure 7.
Figure 6. Model 1069 (RJ-45) POTS/ISDN interface.
The Interconnecting cables shall be acceptable for
external use and shall be rated for the proper applica-
tion with respect to voltage, current, anticipated tem-
perature, flammability, and mechanical serviceability.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1 TX+/RX+
2 TX-/RX-
3 RX+/TX+
4 (no connection)
5 (no connection)
6 RX-/TX-
7 (no connection)
8 (no connection)
1 (no connection)
2 (no connection)
3 (no connection)
4 (2-wire RING)
5 (2-wire TIP)
6 (no connection)
7 (no connection)
8 (no connection)
11
Advertisement
Table of Contents
