Draytek VigorAP 700 User Manual page 46

Here are descriptions of every setup item:
Key Length
Key Format
Default Tx Key
Encryption Key 1 to 4 Input WEP key characters here, the number of characters must be
Enable 802.1x
VigorAP 700 User's Guide
There are two types of WEP key length: 64-bit and 128-bit. Using
128-bit is safer than 64-bit, but it will reduce some data transfer
performance.
There are two types of key format: ASCII and Hex. When you select
a key format, the number of characters of key will be displayed. For
example, if you select 64-bit as key length, and Hex as key format,
you'll see the message at the right of Key Format is 'Hex (10
characters) which means the length of WEP key is 10 characters.
You can set up to four sets of WEP key, and you can decide which
key is being used as default here. If you don't know which one you
should use, select 'Key 1'.
the same as the number displayed at Key Format field. You can use
any alphanumerical characters (0-9, a-z, and A-Z) if you select
ASCII key format, and if you select Hex as key format, you can use
characters 0-9, a-f, and A-F. You must enter at least one encryption
key here. If you entered multiple WEP keys, they should not be the
same with each other.
Check this box to enable 802.1x user authentication. Please refer to
38