Ap Bridge-Point To Point Mode - Draytek VigorAP 700 User Manual

2-4-3 AP Bridge-Point to Point Mode

In this mode, this VigorAP 700 will connect to another VigorAP 700 which uses the same mode,
and all wired Ethernet clients of both VigorAP 700s will be connected together. You can use this
mode to connect a network to another network which is physically isolated.
Please note that when you set your access point to this mode, it will not accept regular wireless
clients anymore.
When you select AP Bridge-Point to Point, the following screen will be displayed:
Here are descriptions of every setup item:
Band
Channel
Please select the wireless band you wish to use. By selecting
different band setting, you'll be able to allow or deny the wireless
client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz (G), only wireless
clients using the wireless band you select (802.11b, 802.11n, or
802.11g) will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless clients using
802.11b and 802.11g band will be able to connect to this access
point.
If you want to allow 802.11b, 802.11g, and 802.11n clients to
connect to this access point, select 2.4GHz (B+G+N).
Please select a channel number you wish to use. The channel
number must be same with another VigorAP 700 you wish to
connect.
23
VigorAP 700 User's Guide