Ap Mode - Draytek VigorAP 700 User Manual

Universal Repeater
Please select one wireless operating mode. For detailed descriptions of every operating mode,
please refer to Section 2-4-1 to 2-4-6 listed below.

2-4-1 AP Mode

This is the most common mode. When in AP mode, the access point acts as a bridge between
802.11b/g/n wireless devices and wired Ethernet network, and exchanges data between them.
When you select AP, the following screen will be displayed:
Here are descriptions of every setup item:
Band
to accept wireless clients while the access point is working as
a wireless bridge.
This product can act as a wireless range extender that will
help you to extend the networking wirelessly. The access
point can act as Station and AP at the same time. It can use
Station function to connect to a Root AP and use AP function
to service all wireless clients within its coverage.
Please select the wireless band you wish to use. By selecting different
band setting, you'll be able to allow or deny the wireless client of a
certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz (G), only wireless
clients using the wireless band you select (802.11b, 802.11n, or
802.11g) will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless clients using 802.11b
17
VigorAP 700 User's Guide