Draytek VigorAP 700 User Manual page 40

Device Configuration
Note: When you're using PBC type WPS setup, you must press PBC button (hardware or
software) of wireless client within 2 minutes. If you didn't press PBC button of wireless
client within this time period, please press PBC button (hardware or software) of this
access point again.
VigorAP 700 User's Guide
set on this access point, nothing will be displayed here.
Config Mode: There are Registrar and Enrollee modes for the WPS
connection. When Registrar is enabled, the wireless clients will
follow the access point's wireless settings for WPS connection.
When Enrollee mode is enabled, the access point will follow the
wireless settings of wireless client for WPS connection.
Start PBC: Click Start PBC to start Push-Button style WPS setup
procedure. This access point will wait for WPS requests from
wireless clients for 2 minutes. The WLAN LED on the access point
will be steady on for 2 minutes when this access point is waiting for
incoming WPS request.
Start PIN: Please input the PIN code of the wireless client you via
client wish to connect, and click Start PIN button. The WLAN
LED on the access point will be steady on when this access point is
waiting for incoming WPS request.
32