Vivotek FD8162 User Manual page 76

VIVOTEK
Auto: If you set Exposure mode as Auto, the Exposure time and Gain control will be not configurable
since the sensor library will automatically adjust the value according to the ambient light� Then you can
set iris mode as "indoor" or "outdoor" to reach the best image quality�
You can click Preview to fine-tune the image, or click Restore to recall the original settings without
incorporating the changes� When completed with the settings on this page, click Save to enable the
settings�
If you want to configure another sensor setting for day/night/schedule mode, please click Profile to open
the Profile settings page as shown below.
Please follow the steps below to setup a profile:
1� Check Enable and apply this profile�
2� Select the applied mode: Day mode, Night mode, or Schedule mode� Please manually enter a range
of time through which you want the Schedule mode to apply�
3. Configure Exposure control settings in the folowing columns. Please refer to the previous page for
detailed information�
4� Click Save to enable the setting and click Close to exit the page�
76 - User's Manual
2011/03/13 17:08:56