Hardware Installation - Vivotek FD8162 User Manual

Hardware Installation

Before installing your camera, make
sure the built-in PIR (Passive Infrared
Sensor) can be directed toward the
a r e a o f i n t e r e s t , w h e r e p o s s i b l e
intrusion may occur� (The sensitivity
of PIR sensor depends on the object
size and temperature differences
between the object and the background
environment�)
Use the included T10 Torx screwdriver to loosen screws on the sides of dome cover to remove it� You
should then jot down the MAC address printed on the bottom of the camera�
Remove the black cover as shown below so that you can fine-tune the focus and zoom the
camera later when the cabling is done�
50
5m
50
Dome Cover Dome Cover
Bottom of the Camera
Tilt Adjustment
Screw
Top View
5m
41
41
VIVOTEK
Side View
Focus Ctrl
Zoom Ctrl
User's Manual - 7