Table of Contents
Advertisement
Analog outputs.
The analog outputs of the PHASE 28 system operate with musi-
cian-friendly line levels of +4dBu (plus headroom, typically 2.1
volts RMS). Here, you can connect a mixing board, active speak-
ers, or amplifiers.
The PHASE 28 system is equipped with 8 analog outputs, which you can address
independently of one other. The connections are in 6.3mm cinch format and offer a
balanced signal path to minimize interference.
In the driver as well as the PHASE ControlPanel, the outputs are always treated as pairs
(thus, for example 1/2, 3/4, 5/6, 7/8), when the application in use supports pairs. Of
course, you can also control the channels separately (in mono). However, you will usually
control the volumes from within the audio software application you use.
The output level of all channels is set to approximately +4dBu and also offers sufficient
headroom if required in your productions (including headroom, typically 2.1 volts RMS).
Practical tip: Make full use of the 24-bit support of up-to-date
software applications and connected digital peripherals- even if
you are planning to "just" release your production on CD. The
additional sound quality is audibly worthwhile, both in the sum of
the signals and, above all, during digital post-production.
18
PHASE 28 (English)
Advertisement
Table of Contents
