Monitoring; Selecting The Cr Source - Tascam DM-4800 Owner's Manual

4 – Routing & assignment : Monitoring

Monitoring

The DM-4800 provides comprehensive monitoring
and metering facilities allowing both control room
(for both large and small speaker sets) and studio cue
mixes to be produced.
Figure 4.7: Monitoring and metering controls

Selecting the CR source

The dedicated keys and indicators to the right of the
meters allow instant switching of the control room
monitor sources and the two
which mirror the output from the control room moni-
tor outputs.
The first key is hard-wired to the stereo buss
( ) and cannot be changed.
STEREO
66
TASCAM DM-4800 User's Manual
outputs,
PHONES
This section describes the monitoring procedures and
setup when working in stereo. When working with
surround mixes, there are obviously some important
differences, and these are described in "Surround
operations" on page 88.
The next six keys, in order, default to the aux 1–2
sends (typically used for studio cue), the aux 3–4 and
aux 5–6 sends, digital input 1 and digital input 2 (e.g.
stereo recorders) and the analog 2-track inputs
(again, this could be an analog stereo master
recorder).