Eq Controls; Aux Send Levels; Pan Control - Tascam DM-4800 Owner's Manual

2 – Basic operational concepts : "Fat channel"

EQ controls

Press the SCREEN key to bring up the EQ screen for
the currently-selected module.
Turn the EQ on and off for the module using the
key.
Gain and frequency for the four EQ bands are
adjusted with the top row of four encoders (
and bottom row ( ).
FREQ

Aux send levels

Press the SCREEN key to bring up the aux/buss
screen for the currently-selected module.
Use the appropriate control to adjust the Aux send
level for the selected module.

Pan control

The control to the right of the Aux send controls
PAN
may be used as a pan/balance control for a selected
module or pair of linked modules.
28
TASCAM DM-4800 User's Manual
Figure 2.21: Equalization controls
To set the type of filter for a band, press and hold the
CTRL
priate encoder in the top row (
ON
If the width of a filter (Q) can be set (depending on
the filter type), you can do this by pressing and hold-
ing the
)
GAIN
encoder in the bottom row (
Figure 2.22: Aux send controls
If two aux sends have been linked, the odd-numbered
controller acts as a pan control, panning the send
between the two aux sends, and the even-numbered
controller acts as a level control.
In surround modes, it controls the L/R balance of the
surround matrix.
key to the left of the unit, and turn the appro-
TYPE
key and turning the appropriate
CTRL
).
Q
).