Location Memories; Selecting The Location Point Display; Storing A Location Memory "On The Fly; Manually Entering And Editing A Location Memory - Tascam DM-4800 Owner's Manual

Location memories

The DM-4800 allows the storage and recall of up to
ten location memories, allowing easy location of the
controlled devices to predetermined cue points.

Selecting the location point display

As explained in "LOCATE DISPLAY mode" on
page 42, the LOCATE DISPLAY MODE
OPTION SETUP screen is used to determine whether the
LED time counter shows the location memories as
they are entered, edited and recalled, or whether they
are shown as "popup" panels on the LCD display
screen.
Storing a location memory "on the fly"
This procedure allows you to set a location memory,
regardless of whether timecode is currently being
received or not. If timecode is not currently being
received, the value of the location memory is the last
received value as shown on the time counter on the
display.
The value on the time counter, regardless of source,
is stored as the location memory. This may be
timecode or MTC.

Manually entering and editing a location memory

The procedure below can be used for editing existing
location memories or for adding new ones:
1 Press the key. The indicator starts to
EDIT
flash.
2 Press one of the number keys to select the
location memory which will store the value.
The indicator lights steadily.
EDIT
3 Enter the timecode value using the numeric
keypad. The display shows the value, "filling
up" from the right digit towards the left.
Or, if the key is pressed again after the
EDIT
location memory number has been pressed,
the indicator starts to flash again, allowing the
8 – Remote operation : Location memories
setting in the
When this section mentions "the display" showing
location memory values, this refers to the display
that has been selected in this option.
NOTE
Depending on the settings for frame display ("Edit
Frames" on page 109), the frames value may or may not
be shown on the display when location memories are
being edited, etc.
1 Press the
key. The indicator starts to
MEMO
flash.
2 Press any of the numeric keys, corresponding
to the ten location memories available.
3 The indicator stops flashing and the
MEMO
currently-displayed timecode value is stored
in the location memory corresponding to the
numeric key which was pressed.
checking and editing of another location mem-
ory.
4 Press the key when the timecode value
ENTER
for the location memory has been entered.
5 Press
EDIT again once to edit another location
memory, or press
EDIT
tion memory editing mode.
If the key is pressed before the
CLR
key, a location memory entry which has been
made in error is cleared. Pressing
stores the cleared memory.
It is possible to switch between the capture, edit and
location procedures at any time.
TASCAM DM-4800 User's Manual
twice to exit the loca-
ENTER
ENTER
115