Mixer Controls That Can Be Used When In Daw Control Mode - Tascam 12 Manual

Mixer controls that can be used when in DAW control mode

The following Model 12 controls can be used when in DAW control mode.
o The blue knobs, switches and faders in the illustration below are enabled.
FX fader
MULTI JOG dial
Function buttons
DAW CONTROLLER MARKER screen
o Use the F2
button to set markers.
o Use the F3 and F4
markers.
NOTE
The status of the DAW application SOLO switch is shown by
the SOLO item on the DAW CONTROLLER screen.
–: SOLO switch off
0: SOLO switch on
This operates the DAW master fader.
This can be used for locating.
Their functions depend on what is shown on the DAW CONTROLLER screen.
Press the MENU button to switch function button operations.
buttons to move between
Model 12 operations
DAW CONTROLLER TRACK screen
o Press the F2
button to change the DAW repeat
function.
o Use the F3 and F4
tracks that can be controlled.
ATTENTION
After changing the tracks that can be controlled, the DAW
settings and the state and positions of the Model 12 buttons,
knobs and faders will not match. In this case, adjust the DAW
settings to match the Model 12 settings, or use the Model 12
buttons, knobs and faders to match the DAW settings.
TASCAM Model 12 DAW Controlmode Manual
buttons to move among
5