Snom 100 v1.5 User Manual page 51

administrator which value should be set within your
network.
Press the menu key in the idle state and select the
submenu "Settings / Network / GK-GW Mode":
Gatekeeper: The phone is in gatekeeper
§
mode. Set the IP address of the gatekeeper in
"Settings / Network / GK-GW Address".
None: The phone is used without a gatekeeper
§
and without a gateway.
Auto: The phone is in gatekeeper mode but it
§
uses a multicast to automatically detect it.
Gateway: The phone is in gateway mode. Set
§
the IP address of the gateway in "Settings /
H.323 / GK-GW Address".
GK-GW Address
Whether the phone is set to gatekeeper or gateway
mode (see "GK-GW Mode") here the IP address is set.
Press the menu key in the idle state and select the
submenu "Settings / H.323 / GK-GW Address".
Fast Connect
When setting up a call H.323 normally first sets up the
connection and then begins to negotiate the codecs.
With terminals a long way apart the beginning of the
call could be lost. In order to avoid this "Fast Start"
was invented, i.e. the codecs supported are sent
immediately so
established is lost. Unfortunately, some terminals
cannot handle fast start correctly. While normally this
parameter should be set to "on", it should be set to
"off" if you encounter problems to setup a connection.
Press the menu key in the idle state and select the
submenu "Settings / H.323 / Fast Start".
On: „Fast Start" is enabled.
§
Off: „Fast Start" is disabled.
§
no further time
51
after the call